oldsaw
"Been There, Milled That"
Last week I posted about my 066 dying in the cut when milling after losing power, but restarting immediately and having full power right afterwards. I had guessed at a fuel problem, since it seemed to act like one. However, the fuel filter is clean, there are no holes in the fuel line, PLENTY of fuel is flowing to the carb (I pulled the carb with half a tank of fuel..my hands and shoes now smell like gas...that isn't the problem), checked the tank vent (worked perfectly), carb is perfectly clean and functional (recently rebuilt, worked fine for past year and a half). I'm kind of off the fuel kick, unless the filter is floating to the top of the tank and causing fuel starvation, but this has never happened before.
Ignition is possible, but I've never seen one quit and immediately start again and run fine.
Any guesses from here?
Mark
Ignition is possible, but I've never seen one quit and immediately start again and run fine.
Any guesses from here?
Mark