Stihl 015 Build Thread

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

eiklj

ArboristSite Guru
Joined
Dec 1, 2011
Messages
509
Reaction score
200
Location
Kansas
Hey guys, I've seen alot of posts recently about the little 015 top handle saw that Stihl made for many years.
I bought this white one from another member here on AS and he asked if I could post up a thread on the build.
I says Sure!
I've done many of these and have several that I use for parts when these come thru the shop.
So follow along and I'll take you thru a complete re-assembly with lots 'n lots of pics.
I'll also show some things to look out for as Stihl changed some things throughout the production run of these saws.

Here's the one I'll be building:
View attachment 257690
attachment.php


And here's the one I already own, an orange 015AV.
View attachment 257691
attachment.php
 
The 015 came from the factory with ¼" and 3/8" pitch chain. If you have one that is ¼" and want to change it to a more common 3/8" Low Pro, then you must change the white plastic worm drive because the sprocket teeth have to mate with it. This is what will drive the oil pump spur gear in the previous pics.
View attachment 257699
attachment.php


Unfortunatly, this 3/8" spur sprocket is NLA thru Stihl, at least according to MediaCat 2012. I'm not sure if Oregon still offers a replacement?

View attachment 257700
attachment.php
 
The 015 I am rebuilding had the flywheel in the lower left corner. It had a broken fin, not big deal, probly OK to use, but since I had another good one, I'll use it.
But before I toss it, I'll salvage the pawls and springs by tapping out the pins that hold them.
The one at the top right has a bad spring that I can replace.
View attachment 257701View attachment 257702View attachment 257703
attachment.php

attachment.php

attachment.php
 
I've cleaned up both halves of the front handle and case, ready for a new gasket to go in. The wire wheel on the bench grinder works great for this.
The gaskets are still available so I usually keep 3 or 4 in stock at all times.
View attachment 257715
attachment.php
 
Here's a pic showing the original fuel and cracked oil line on the right and a new fuel line installed on the left.
View attachment 257716
attachment.php


Here's the replacement fuel line from the MS250, 021, 023, & 025.
View attachment 257717
attachment.php

I've installed a large fuel pick-up filter on mine but if you want the ability to replace the fuel line without dis-assembling the entire case, then install a smaller fuel pick-up body like in the above photo. This lets you pull the entire fuel line and pick-up thru the hole in the case. I don't plan to replace mine anytime soon, so I leave the larger pick-up filter in place for now.
View attachment 257718
attachment.php
 
I have a new stihl spur you can have if you will pm me your address. I bought it for the first saw I ever had which was an 015L and the saw got stolen the day before the spur showed up. It is just like the left one in the picture.
 
Put the handle cover on and hold it with these 2 screws.
View attachment 257719
attachment.php


Now you can smear some Dirko in the mating surface before you set the engine in place.
Do NOT forget the kill wire and grommet. You WILL be taking everything back apart if you forget this. I know.
View attachment 257720
attachment.php


Then just tighten the 4 long screws and 2 short screws and the engine is done.
View attachment 257721
attachment.php
 
Back
Top