coldfrigman
ArboristSite Lurker
Again, thanks for the help. I ordered seals and will try that fix.
Stihl 028 AV
- Thread starter coldfrigman
- Start date
Help Support Arborist Forum:
I believe the028 is a mag case. If so a heat gun can make it a lot easier to get them out just don't cook the bearings to much, keep the gun moving. And take pictures as you take it apart to help with the reassemble. Let us know if it fixes your problem.
coldfrigman
ArboristSite Lurker
I replaced the larger seal near the oiler. Question. Stupid question, but oil should NOT be coming out of the center of the plastic tooth worm gear oiler sprocket, right??? I noticed a small pin size hole in it on the outside. When I turned the gear it pumped oil out of the center???
coldfrigman
ArboristSite Lurker
I have now replaced the crankshaft seal on oiler/blade side. The rope pull side was completely dry, after viewing once I pulled the flywheel. Oiler seams to be tossing oil out to the openings on top of housing. Anyone know why I seem to have oil blowing out the muffler? New piston and rings were put in. Thanks for the help
