Buck1278
ArboristSite Operative
I'm going to look at an 051 with a 30" bar and is hooked up to an alaskan mill. Is this a good saw with this set up for milling?
Stihl 051
- Thread starter Buck1278
- Start date
Help Support Arborist Forum:
mtngun
Addicted to ArboristSite
No experience with the 051 but it's an old saw, and 30" is not much for milling (24" cut width).
Similar threads
Latest posts
-
Oil and fuel/oil recommendation for break in of new Husqvarna 135 Mark ii- Latest: TheJollyLogger
-
Scrounging Firewood (and other stuff)- Latest: MustangMike
-
-
-
Want to Sell NEW WALKERIZED HUSQVARNA 3120 PORTED MODDED SAW POWERHEAD $1945usd SHIPPED- Latest: thechainsawguy
-
-
-
