Get in line buddy! Got any big logs?Do i get to run it ?
Get in line buddy! Got any big logs?Do i get to run it ?
Get in line buddy! Got any big logs?
Yes it is!Lookin' good! Crank centered and spinning freely?
Won't fit so I ordered one today!Are you gonna keep the chip deflector ? , and FYI i like the putter
Won't fit so I ordered one today!
Is there a WECSOG way of centering a crank without a special tool? How do you do it Brad?Lookin' good! Crank centered and spinning freely?
I checked it against my 026 and the spacing is off there also. Now I have to find a saw to fit it!keep it , you will need it somewhere down the line..but im suprised it doesnt fit..i even have the same one on my 261
Is there a WECSOG way of centering a crank without a special tool? How do you do it Brad?
Basically!Smack it with a hammer. 100% WECSOG lol
I could break an anvilSmack it with a hammer. 100% WECSOG lol
Haha not that hard!I could break an anvil
Let the heat work and some taps with the plastic tipped hammer. I have to get some of those tools!Lookin awesome dan...smooth sailing from here on out!!! How did you pull the crank through the flywheel side. I "cheat" and use the stihl as and zs tools. Just got done with an 036 lower end tonight.
Enter your email address to join: