Stihl 066 wont start after carb rebuild

[Baddboyy21]

I figured out the problem. The metering spring that came with the carb kit is way too small. This was causing it to flood. I replaced it with the original and everything works fine now. While fixing that issue, I discovered that the oil pump is not pumping any oil at all. Should I go used, Or NOS? I'm not putting chinese parts in the saw.

 

[Baddboyy21]

When I say the spring was too small, I mean too short.

 

[HarleyT]

When I say the spring was too small, I mean too short.

My wife considers that as pretty much the same thing.

 

[HarleyT]

I figured out the problem. The metering spring that came with the carb kit is way too small. This was causing it to flood. I replaced it with the original and everything works fine now. While fixing that issue, I discovered that the oil pump is not pumping any oil at all. Should I go used, Or NOS? I'm not putting chinese parts in the saw.

You should check and see what is wrong, might be a simple clog, or something else real simple.

 

[Baddboyy21]

My wife considers that as pretty much the same thing.

Haha. Don't they all?

 

[Baddboyy21]

You should check and see what is wrong, might be a simple clog, or something else real simple.

I'll have to dig into that tomorrow