I recently acquired a nearly full spool of low profile semi-chisel. I know it’s 3/8 & .050 and low profile. This is the size I run on all my saws (minus the MS150TC, for obvious reasons). However, I have always run RS or RSF.
What little info I have found, is that it’s not recommended for anything bigger than 40cc/2.5hp. Excluding my 150 top handle, my smallest saw is a 261 and then it’s a 362CM and up.
What I’m looking for, is any info or experience anyone has with this chain. It has yellow master links, but the warning I read on bailey’s for the loop that was available (appears to be phased out now) has me nervous to run this chain.
What little info I have found, is that it’s not recommended for anything bigger than 40cc/2.5hp. Excluding my 150 top handle, my smallest saw is a 261 and then it’s a 362CM and up.
What I’m looking for, is any info or experience anyone has with this chain. It has yellow master links, but the warning I read on bailey’s for the loop that was available (appears to be phased out now) has me nervous to run this chain.