Heyas!
Before I wreck Stihl MS 200 muffler for good I better ask here for help =)
Exhaust pipe had thick carbon layer I decided Ill remove muffler and clean it.
After removing two bolts from the bottom I tried to raise the J-profile thingy on end of exhaust pipe, tried pry top plate up, but no go. The side shield opens a tiny bit on top but I'm afraid I'd break something if that ain't proper way to open it. So if you know how to do it please share.
Search gave away MS 200T had loctite used to secure bolts but could manufacturer/tech used it to seal the joints as well?
Before I wreck Stihl MS 200 muffler for good I better ask here for help =)
Exhaust pipe had thick carbon layer I decided Ill remove muffler and clean it.
After removing two bolts from the bottom I tried to raise the J-profile thingy on end of exhaust pipe, tried pry top plate up, but no go. The side shield opens a tiny bit on top but I'm afraid I'd break something if that ain't proper way to open it. So if you know how to do it please share.
Search gave away MS 200T had loctite used to secure bolts but could manufacturer/tech used it to seal the joints as well?