Honest John
ArboristSite Operative
I've been working on a MS250 today and I can't for the life of me figure out why its not getting spark. I started by switching out the ignition module from an 025 parts saw that I had. It looked different but fit just fine. When I switched them, I notice the pigtail coil inside the boot was a little loose so I pulled the boot off to re-seat the pigtail wire and then put the boot back on the 025 coil.
Still no spark....next step was to try a different plug. No luck there. After that, I switched out all the wiring from the 025 to the MS250....still no spark.
Any ideas on what I might be missing ?
John
Still no spark....next step was to try a different plug. No luck there. After that, I switched out all the wiring from the 025 to the MS250....still no spark.
Any ideas on what I might be missing ?
John