Sold Stihl MS440 Magnum

[dustinwilt68]

Bought this saw locally with a broken oil tank, I found an used oem replacement and had it installed with all new crank seals,bearings, case gasket and cylinder gasket,All factory stihl parts, NO aftermarket parts, I made the video and since then I have adjusted the carb about 1/4 of a torn on the H adjustment, saw runs great now.Asking $500.00

 

[dustinwilt68]

Here is the video

 

[user 122190]

What's that clanging noise during the 2nd noodling?

 

[dustinwilt68]

It was a loose muffler bolt, someone else pointed that out, I tightened it up. The dealer must have not tightened it the entire way. I can make a new video if you would like

 

[user 122190]

I was just curious.

 

[dustinwilt68]

Np, I noticed it myself when I was doing the cuts, that was first time I ran it since I got it back, I adjusted the carb also, was a little lean, and went back through and checked all of the bolts, handle cylinder, muffler, covers as well.

 

[dustinwilt68]

$475.00

 

[gary courtney]

what rpm is it pulling in cut? sounds a little low .

 

[dustinwilt68]

Yes I had to adjust the carburetor, I had just got it back from the dealer putting the new seals, bearings and such in it. I dnt have a tach, but I set it back to 3/4 of a turn on the H setting which is where the factory says to put it and it runs much better.

 

[dustinwilt68]

Bum

 

[Da83moon]

Does it come with bar and chain, or is it PHO?

 

[dustinwilt68]

PHO, for that price, add $40.00 for the b&C .

 

[dustinwilt68]

Any interest before I take it to ebay?

 

[dustinwilt68]

$450.00

 

[dustinwilt68]

New video after I tuned the saw

 

[RyeThomas]

What size is the bar and chain for $40?

 

[dustinwilt68]

20" stihl ES bar and not sure of the brand on the chain.

 

[IronSpruce]

still for sale ?

 

[dustinwilt68]

Yes it is.

 

[dustinwilt68]

Open to offers, need funds for my 6100 project.