ok here it is I am ready to clean up the work bench and start rebuild on my sxl 925 I purchased a new jug and piston and gasgets Ive rebuilt lots of engines but never a chain saw I noticed that some of the edges of the new jug are a bit sharp should I sand them a bit and with what grit if so lube with anything special ? and last should I do anything with the muffler? I was running the saw on its side ripping or what ever you call it and it seized this happened twice the first time I let it cool and later put a little oil in the jug and ran it again the piston is badly scored but the old jug looks quite usable yet although im using the new one thanks guys for any help.
oh ya stihl pro 036 since the homey blew up sthil ts 460 and a few dept store poulans