outdoorsman0490
ArboristSite Operative
Recently put my order in on a bandsaw mill. I opted for the electric motor for the much less noise primarily. Doing some research for the electrical before I have an electrician I know come over to wire it, so I have an idea what he is talking about.
Motor info is 10hp, 230 volts, draws 44 amps, single phase.
The manufacturer says to run for 80 amps, so 4awg and an 80 amp fused disconnect.
I am going to make a building for this mill, so for now the mill will be outside until I have milled enough wood for the building.
For now, going to unplug mill and wind up the wire and bring back in house. I will eventually bury the wire and pop it up in the building.
This wire looks like the best deal I have found online. Just double checking any of you electrical guys out there can confirm, or point me in a better direction.
https://www.wireandcableyourway.com/4-3c-thhn-pvc-tray-cable-with-ground.html
Motor info is 10hp, 230 volts, draws 44 amps, single phase.
The manufacturer says to run for 80 amps, so 4awg and an 80 amp fused disconnect.
I am going to make a building for this mill, so for now the mill will be outside until I have milled enough wood for the building.
For now, going to unplug mill and wind up the wire and bring back in house. I will eventually bury the wire and pop it up in the building.
This wire looks like the best deal I have found online. Just double checking any of you electrical guys out there can confirm, or point me in a better direction.
https://www.wireandcableyourway.com/4-3c-thhn-pvc-tray-cable-with-ground.html