Search results

Stihl ms200t ipl and manual Thanks

How about IPL and service manual for ms362

:bang: Never would of thought of that Thanks. And Sefh3 I put your link in favorites that is a good write up. And a big THANK YOU to everyone that helped.

No I didn't do the vac/pres. test. I was going to do that once I got it back together. I had the cyclinder off and I was just blowing air in the crank so I don't think there was any pressure to speak of. I was thinking the saw was running lean and that is what killed the piston.

This is what I got for part # 9640 003 1972 Oil seal 18x29.6x5/3 and the other is: 9640 951 1972 Oil seal 18x29.6x5/3 Cat. Is there a simple way to get the seal out without Stihls special tool also what about installation of the seal? I was just looking at IPL and do I have to split case to...

I did a compression check on my 044 and it was 120. So i took off muffler and piston was scored. I took the top off and the cyclinder looked good but piston is junk. I order a piston from Baileys but while I'm waiting I took off the clutch and oil pump to clean it up. when I was blowing air into...

036 pro Looking for the service manual and IPL for a Stihl 036 pro. Thanks in advance

Thanks Thanks vw_motorsports for info.

Stihl HT101 Anybody? IPL and service manual Thanks

Stihl ht101 Still looking for service manual and IPL Thanks

Stihl HT101 I know this isn't a chainsaw but if somebody could help I could use it. I am looking for the service manual and the IPL. THANKS

I burned 5 1/2 cord so far and have 1/2 cord stacked by OWB. Will have to bring some up from my 4 year supply. But the wife loves the house at 72/74*

Sthil MS250 How about an IPL and service manual for the MS250 Thanks in advance

Ms660 Anybody got the IPL and the service manual? Thanks in advance

Stihl 015L Still looking for a service manual for stihl 015L Thanks

Stihl 015L Can anybody help me out? I need the service manual and an IPL for the 015L Thanks

stihl 023 Any help on a 023 for an IPL and service manual? Thanks

What should be the gap from the flywheel to the coil? Any help would be appreciated. Thanks

I have the same splitter with the same problem as in pic 1. I added a piece of rubber so it rubs on that instead of the hose. I don't have the kink as in pic 2

I thought Heatmor pulled the air from around the bladder hole which heats it up a little but I could be wrong. My fan can have a blazing fire in a minute with dry wood on top of the coals.