ronT2
ArboristSite Guru
The second ones are some nasty lookin dawgs.
Here’s Chainsawwhisperer and his 750 with the nasty dawgs.
Here’s Chainsawwhisperer and his 750 with the nasty dawgs.
Well, my homelite 750 gas tank sealer finally set up. Seems to be keeping the gas and bar oil from mixing so far. I hope it stays that way
Now, my next mission is to make some dawgs for it. Does anyone have a pattern for them? Maybe a scanned picture that's actual size?
There some 650 750 dawgs on ebay that seem reasonable.
Lee
That looks great! Don't think I'd try stainless. Still remember how fun it was trying to make a shim outa stainless for the Northern grinder. You did a nice job on that spike though.
Dan
Still fires,,i never DID say anything about RUNNING !!
Most i can get out of it is to run off the gas from chokeing it then dies or run with choke full on and that dont last but a few seconds..
Now just read the above posts about tank gunk and such and the PO told me he had fuel line replaced and was goobers in the tank..
he ALSO told me it was running fine when it quit on him.....
So i'm thinking he didnt have it very long and there is a fuel delivery problem..
thinking i will blow back thru fuel line to check for obstructions..
plug one end and check for leaks in new line..
check the metering diaphram and fuel pump on the carb..
Then check out the carb boot..
Tnx..
Well, Did you ever get that 750 running???
Enter your email address to join: