The mag air filter cover saws have the best cylinders, but they run a lot better with the HD filter set-up. I mean, if you care about that sorta thing.
The clutch side I think you have to get from stihl it has the place built in bearing for seal to press into
the clutch side does not have to be stihl
9010 ral number is the powder we use on newer stihl
http://www.arboristsite.com/community/threads/stihl-064-restoration.239765/
if your gonna powder bake the raw parts to draw the oil out of metal
randy went over this before a kolbinsmit (I think that's the name it begins with a K) cyl has better port timing
That's kind of where I'm leaning. I figure the old clutch side is a plastic cage so even an aftermarket bearing would be better in most cases than an old one with that variable.
not to derail, but what is the DuPont single stage called?The tank breather was crusty. .I actually grew up in a body shop so I'm all over that. The white I have is DuPont single stage acrylic urethane.
Me too, brotha.Always like to hear about someone rebuilding an 064, my favorite Stihl saw.
Enter your email address to join: