There you go John.
Please don't take all my work now.
Anytime I've been paid for something it seems like work. No threat here man, ill stick to messing with mine and my buddies saws. Besides I don't want to pay royalties on others numbers.
There you go John.
Please don't take all my work now.
Woot woot. Where did you order that from? And how much. Is the 1/8 inch
off the roll 33rs, 9 pin, needs 11 pin
off the roll 33rs, 9 pin, needs 11 pin
Yeah.... Maybe it will cut fasterVery cool but sink it in some white oak, not the same effect
off the roll 33rs, 9 pin, needs 11 pin
off the roll 33rs, 9 pin, needs 11 pin
The more i se the tig gun again the more i want one just cause.The more I see these piped saws, the more I want one. Just cuz
Hows the lower rod bearing look?Tonight's patient...a 577 Shindaiwa. Bad bearings and seals....
They were toast. In go some slick new German FAG manufactured ones...I warmed the cases to 180F, chilled the bearings to 0F. They dropped in with finger pressure
A little Hondabond HT (no gasket in the 577 series saw) seals it up, and we have a freshened up 577 bottom end....time to grind on the jug a bit next.
Mechanic's fuel...
Make them from flat cold roll is best, .024" thick is what I've used. No prefab parts.Making um from nothin... Or can you buy pre-made pieces ?
Let's see that poulan pipe!Yeah i need a pipe for the 026 now or 034. My poulan with a pipe is my go to saw and everyday i want to run a tank of few through it of course with ear protection
Enter your email address to join: