Now that mine has most of a tank through it, when cold it pops on the first one and starts 2nd or 3rd. This thing either has a much bigger gas tank than in used to or its a fuel sipper. I did some noodles before that vid to warm it up and tune the carb, that vid, and dropped 3 8" trees (in the way of dropping some dead wood), limed and bucked. Still had gas in the tank when I had to run into the house from the random downpour.
I'm not impatient. I just have this bar that I'm not using and didn't know if it could be modified or not. I've seen some husky brand.050 bars on eBay for $55 for a 24". The one I have is a 20.Just buy a large mount woodland pro, or if you're inpatient I think you can get a husky branded one at tractor supply for a little more money.
Bottom end and cylinder together now
Has 0.060" squish as assembled
How are you going to invert the seal? It's going the other way. And like I said, pushing on the inner races is overrated.
But that's the same direction as putting in the seal with the crank installed.
If the crank and bearings were a tighter fit I'd agree. But mine at least pulled together with minimal effort.
Enter your email address to join: