Aggie, you win ... but a roller tip bar would still give you some more limbing speed.. :hmm3grin2orange: :hmm3grin2orange:
Aggie, you win ... but a roller tip bar would still give you some more limbing speed.. :hmm3grin2orange: :hmm3grin2orange:
Aight Belgian, put some of your monsters up!
More pics, more pics, more pics.
here is one or two, Should have more on the other computer...
LOL, I don't think my oldies fit right in this thread
Yeah maybe, but I'd still look.
Ok then, because you heathens insist, LOLOL.
Beat this ....:hmm3grin2orange:
...
Roland
Roland
.
Well, that one is probably used less than this one:Ok then, because you heathens insist, LOLOL.
Beat this ....:hmm3grin2orange: :hmm3grin2orange:
...
Nice looking old timers. I'm guessing circa 1965, maybe a little earlier?Heres my Poulan limbing saw.
You are kidding me? Put a 15" bar on an MS 361? What on earth would a 15" chain be able to do with all that horsepower to release?Jokes aside :jawdrop:
..a really cool limbing saw is the MS361 with a 15" bar, and 3/8x8.....
You are kidding me? Put a 15" bar on an MS 361? What on earth would a 15" chain be able to do with all that horsepower to release?
Reminds me of my hot rod and pony car days. Remember the Hemi 'Cuda?
You are kidding me? Put a 15" bar on an MS 361? What on earth would a 15" chain be able to do with all that horsepower to release?
Reminds me of my hot rod and pony car days. Remember the Hemi 'Cuda?
You are kidding me? Put a 15" bar on an MS 361? What on earth would a 15" chain be able to do with all that horsepower to release?
Reminds me of my hot rod and pony car days. Remember the Hemi 'Cuda?
Believe it or not, it is my most common setup for limbing and bucking (in the woods), unless the trees are really small, like thinning victims - or I take another saw, just for kicks......
Most trees aren't more than 18" here, and a 15" bar does nicely, with some "overbucking".
It will be replaced by a 16" one when worn out, though.
What about those guys that put bigblocks in vega's and pinto's.
Enter your email address to join: