NC Hillbilly
ArboristSite Member
Is that the only time you notice odd behavior like this?
Does the tone change when you tilt the saw around?
Did you clean the carb and/or kit it?
Have not had any time but a few minutes here and there to tinker. It is only the second time running it, and have not done a thing to it other than getting the grime off. It does it every time after it rev it, but comes back down to a nice burbly idle after a few seconds. I did not tilt it around any, just had it sitting on an old stump. I did check the throttle, it was not hanging and the shaft did not move after I let off of the trigger. I will give it a try today if possible. Is there an adjustment for the oiler also as it wet the grass within a few feet while running?