MS 460 Questions

[mdavlee]

I've run the 088 max flow on the 046. The filter cage will fit around that spitback guard. I like them for the cleaning interval when milling. If I mill with the filter cover on after one cut the HD 2 is packing up. With the cover off I can go a couple tanks. The max flow will go several outings.

Good deal Brad. It doesn't get any easier losing a parent but it will get tolerable I guess.

 

[MechanicMatt]

The 28inch bar and chain should be in tomorrow UncleMike. I hope he likes it when he gets it back.

 

[MechanicMatt]

Well have to meet up before his party so I can get you the bar, or do you want me to wrap it up and give it to him at the party? None of this is gonna top Colleen flying in from Texas to be at the party, its a surprise so DON'T tell him.

 

[MustangMike]

Yea, I know about the surprise. Wrap the bar & chain, he already has the saw back, but I will take it from him again to put the stuff on.

That Carbide Tip is B/O also!!! I have everything else.

 

[MustangMike]

I removed the carb limiters today. The high speed one came out easy, but the low speed fought with me, but I finally got it.

Went to put the K&N filter on it and it does not fit (even though it said it would). It is too fat. Will have to order a HD-2.

Glad I did not attempt this until I knew he did not need it for a while.