Here is that “335” that was on fleabay which was actually a Super 380
. It turned out to be good in the end. It definitely had a couple minor issues. Compression was good, P&C looked great. Someone did paint the chassis, no big deal, looks ok. One of the lower mounts wasn’t installed correctly, fixed that. It came with a 20” .325 B&C while the saw still had the original 3/8 rim sprocket
.Replaced the rim just in case and put a 20” 3/8 B&C I had. Replaced the 2 shoe clutch with the 3 shoe that came on them. The recoil wasn’t right. They had the 380 flywheel on it and stuck the 335 recoil on it
. That doesn’t work. I put a flywheel and recoil from a 336 I had. Saw wouldn’t start, not a pop. Checked, no ignition, checked switch not that, no biggie I got another module. Went to replace the module found they pinched the kill wire under the ground wire when they put the module back in from painting. So apparently they never ran it after all the work.