Sure is quiet in here....do I need to start a fight?

[Icehouse]

LOL Do you not understand?? I can explain better if need be

What kinda Husky

 

[Welder56]

254xpg

 

[Icehouse]

254xpg

See I'm not as smart as I think I am, I have a few Husky saws and bought them not running but don't remember seeing that part, I should pay better attention. Good luck with your project I'll go away now. lol

 

[Welder56]

Lol!! As far as I can tell from the manual you install the seal (PTO side) in this piece. Hard to read the manual sometimes because all the pictures don't really show up

 

[Icehouse]

The really retarded thing is I've replaced seals in two husky so just never seen that piece removed from saw. Yes if put the seal in that part, and it worked. Can't believe I didn't recognize that part, I'm much smarter now. Thanks for the lesson

 

[Welder56]

Hey its all good. What works is what works. I'm into bearings and a new crank LOL. So everything is off and getting cleaned. Just planning my attack on rebuild time

 

[Icehouse]

Best of luck

 

[Welder56]

Thanks I have a feeling I will need it

 

[Icehouse]

You'll be fine

 

[Welder56]

Lol I know

 

[pioneerguy600]

Now Robin knows much more about Huskies than I but I am certain the seals go in that holder and then it slips on over the crank, that piece has a skinny O ring between it and the crankcase to seal it all up.

 

[Welder56]

That's what I thought Jerry, both of my bearing spacers I have, have the seal in them. So I'm assuming it does. Changed the o ring already (greased it as well)

 

[pioneerguy600]

I changed a few on the 2 series Huskies back in the day, the 266 was the most common around here with the 254 being like second most common.

 

[Welder56]

Too bad a lot of them dissappeared. It's funny my friend has both the 254 and 266. And thats all he has. He worked in the woods around that time frame they were popular.

 

[pioneerguy600]

Seems like they dried up fast, there were a whole lot of them South of us down Bridgewater way when Bowater Mersey still ran the pulp mill. Some of the saw shops down that way may have a lot of carcasses around.

 

[Icehouse]

I like the 200 series saws, bullet proof, simple

 

[pioneerguy600]

I like the 200 series saws, bullet proof, simple

I know 2 pulp cutters that have used husqvarna saws almost exclusively, they ran those 2 series saws right up until 3 - 4 years ago. They just rebuilt them over n over to keep them producing, any saws they stopped using were totally unfixable, worn out or broken, many others that cut pulp were the exact same. There was a pile of orange crankcases out back of their small shop that wouldn`t fit into a 8' pickup bed, about all they would be good for was scrap metal.

 

[Welder56]

That's a lot of unusable carcasses LOL

 

[Stihl 041S]

Page 2?????
Page 2!!!!!!'

Alas.....page 2.....

 

[Icehouse]

Sorry, sorry I must have fallen asleep, never again,I hope