I am not a huge fan of either of the 362 I have to use at work. The intake is always packed full of fines, the bucking spike is almost useless, bolts kept vibrating loose on the recoil until I loctited them. It doesn't seem to have the power it should for the weight. It didn't help the dealer set it on the lean side. Also, the limiters can't simply be removed if I remember, since there aren't any springs to hold the screws in position. Mine has the extra brake in the operator presence lever, which sometimes doesn't work. That's bad news when you get used to it, then all of a sudden it stops working. Or when that brake gets stuck on since sawdust gets in the linkage. Never had any of these problems with the 026 and 044 this saw replaced, it would be nice to have them back. They do start every time though, unless you run it completely out of fuel, then it takes about 15 pulls to get going. It also oils very well. But maybe I really just want the 026 and 044 back since they didn't have flippy caps.