ausneil 1
Addicted to ArboristSite
Still on this 90+cc saw purchase and wondering what chain to run. As the saw will be used for both felling and milling, I'm torn between using 3/8 so can get through a roll faster because it's used on my 20/24/32" bars too, but then I hear .404 holds an edge better in ugly timber and I will be doing a fair bit of bucking for firewood. Also, My 72" milling bar is .404 so I already have to buy .404.
Decision's, derisions what should I do, swap over to 404 when 3/8 will do.......
Hello folkz, been a spell but back for a look see.
edit.... yea ok looked back a few pages that will do.