New 271 vs new 291 vs used 362

[Paragon Builder]

Ok I'll play the huckleberry.

It was stated that a 362 will make 3 cuts for every two that a 291 makes.

So -- in 15 seconds a 291 will make 2 cuts (7.5s average)
-- in 15 seconds a 362 will make 3 cuts (5s average)

If you make a a cut with a 291 in 7.5 seconds and then pick up the 362 and make the cut in 5 seconds then you have improved your cut time by 33%.

What am I missing?
%View attachment 431465

This is correct because it's calculating percent decrease.
Same calculator calculating percent increase

 

[Mr. E]

A used 362 will do it about 50% faster.

This is correct because it's calculating percent decrease.
Same calculator calculating percent increase

My point is you won't get the same amount of work done in half the time with a 362. But you will get done 33% sooner.

 

[Paragon Builder]

Correct. If it was twice as fast you could say the 360 was 100% faster than the 290, or that the 290 is 50% slower than the 360.
It's confusing but that's math.....
Semantics really.
We are all on the same page concept wise [emoji106]

 

[missedbass]

If you are looking at a new 291 why not look at a 261c for a little bit more cash

 

[Greg Perryman]

Dump the 291 idea and go with the 362. I don't need mathematics to tell you this.

 

[Paragon Builder]

Dump the 291 idea and go with the 362. I don't need mathematics to tell you this.

Yeah we kinda derailed the thread for a bit there. [emoji12]

 

[bentbarkbuster]

I understand that you picked Stihl over the Husky, but if you ran a Husky 550 xp I bet you would change your mind. I have both the 362 and the 550 and with a 20" bar on them I would grab the 550 every time. I keep a 24" bar on the 362 just for the bigger stuff because the 362 gets to heavy in the small stuff even with the 20" bar. Unless all your wood is big stuff, might want to look for something lighter.