Search results

Thanks Mark, appreciate the detailed reply. As you know 125 parts are not exactly thick on the ground in the Midwest.

Does anyone happen to know if any other side covers and starter assemblies cross over with sp125 parts? I was looking at other saws and the starter side shrouds look similar but not identical to the 125 parts.

The postman dropped one off for me a few weeks ago he found on the curb along his route. A nice looking Mac 10/10 with a chain brake. Once people figure out you are a saw guy, they will find their way to you. Sent from my iPhone using Tapatalk

Woah, 11 year old thread, back from the dead.

I80 truck stop in Iowa, worlds largest.

Is there a current source for p60 thin rings?

I think I heard that 123.sawman on eBay (Kevin) might have a parts saw.

Sure, I will bite. Pm me a price on the 346.

Probably made on the same tool, in the same Far East factory... Look in the area where there is a stihl part number on the oem part, does aftermarket have grinding marks there?

Not sure, a used one I found. But a harbor freight one can work after a few cycles.

Have they been through an ultrasonic cleaner? With a detergent? Hot water?

Look up welding tips and tricks on you tube. Watch all of Jody's videos, practice, then ask questions.

Need square wave? Have 100 amp plus service? Not sure how far this is from you, but for about 500 these are usually around on craigslist as a Miller 320 or 330 a/bp, or painted orange and branded as an airco. https://rockford.craigslist.org/tls/5428440387.html

Weldingweb.com forum

Yes, the tank (rear handle) was swapped out at some point, no big deal.

The complete one might be a 298

I have a 335xpt husky that does the same thing you are describing, and it is an "almost correct application" cheapie box store Oregon bar with a hollow tail that binds up when the bar nuts are tightened.

Yes, windshield urethane would be good to try. Clean the metal on the bar and insert with solvent first.

Hi tom, yes, some wacker units made by Dolmar use a sem ignition module like this one. http://m.ebay.com/itm/SEM-Ignition-coil-type-G-E-with-flywheel-STIHL-045-056-sachs-dolmar-husqvarna-/262251195213?nav=SEARCH Used in stihls like 056, and also husky 2100/2101. If you have a good used...

Was it ground water from outside? Or a washer hose? Hoping it was not backed up from the sewer.