Search results

I picked up a fresh non running Jonsereds 49sp a few days ago and with it came an unusual bar. It's an Oregon sprocket nose which does not look to have done a lot.(like the saw). The strange (to me ) bit is that the sprocket in the nose is deliberately offset upwards....or downwards if you turn...

I have a B&S xr950 on a splitter. It has always pinked when cold , right from new. It will now only run with a little choke. I have always had a dislike for briggs carbs, but have always found a China replacement to go straight on and do the job by far the simplest solution. I do not seem to be...

A very simple question with perhaps no simple answer. I would like to swap out my rim drive clutch drum on a stihl 261c from Stihl to Oregon. I'm told that while the Oregon rim clutch for a 026 will fit, it is not actually satisfactory. It appears that Oregon do not actually manufacture a rim...

Having become infected by this site some years ago, I now have a good few older 50cc saws...Jonsereds 49sp's, stihl 026's etc. I now hear a lot about the 261 stihl and I may well have a used example sooner rather than later. My question is simply, what else does the autotrophic system do for...

I'm looking for a rim drive clutch sprocket and 8t rim for a Jonsered 2036 in 3/8 pico in the uk. I know it seems a little over the top for such a budget saw but I find it really handy for overgrown garden hedges, bushes etc. What I need is a part number, I can easily find similar for...

I have just recently acquired a single door f400 in very fair condition. In order for me and a mate to get it down a stone staircase and across deep gravel courtyard and into house I had to lighten it a lot, including taking off ash pan housing from base of stove. I'd say it was still a fair...

Hi all. For some few years now I have been in the habit of taking to any "saw it up job" fuel and saw obviously, bar oil, combi bar nut and adjustment tool and a smaller screwdriver suitable for carb adjustment. The small screwdriver is best kept in a pocket, until I bend over...

Hello all. Most here will have made a fresh gasket at sometime. I have not seen a satisfactory method for either transferring outline of part requiring new gasket to the paper, which never seems to be easy to me, or copying old gasket. I'm sure somewhere here there will be...

Hello all. I spend a lot of time on this site looking for info, but don't often post. However, yesterday I was walking down a high street past a skip full of junk and a Johnny 49xp leapt out from under some old plasterboard, scrabbled desperately up the side and shouted for help...

Hello all. Can someone please tell me where i could find a pair of crank seals for my Jonsered 621, alternatively, the correct dimensions for a replacement as i don't want to rip them out unless i have fresh ones on hand. I'm in the uk.

Hello all. I recently aquired a stihl 021 that had been found in shallow water in a canal. A fair bit of it was missing, but after a good amount of cleaning it would run and saw,but very rough eventually stopping from tick over having seemingly flooded. I had a carb kit for its WALBRO wt series...