Where can I get a Carving bar for a ms362

[motolife313]

Stihl doesn’t have one and I’ve got my 362 and 064 to carve with. I’ve got a husky 55 also but needs a pull rope, also have a craftsmen I could try and find. I’d rather use the 362. I’m doing my first carving now. Using my 064 and 25” bar lol

 

[motolife313]

Should I post this in the chainsaw area instead?

 

[rarefish383]

I would think this is the place to go? Maybe some carvers hang out in the chainsaw forum, can't hurt, good luck.

 

[motolife313]

thanks for reaching out but Bought this saw and sold the 362. The 171 works good so far. Got little oak with it so far. Cut a little bit of Fir with it also. For the weight I think it’s got good power so far

 

[Colt Marlington]

171 sounds like a more reasonable size saw for detail work.

I been thinkin about setting up a saw for carving. But I would've never thought to set up a saw over 40cc's.