Moddoo
ArboristSite Operative
I just replaced the outer rear wheel bearings in my 06 gmc 1/2 ton.
62K mi. on it.
I had roughly .010" to .020" radial movement on both sides.
This caused some audible clunking when driving in certain situations.
I've been loading it down with about 3000#+ for almost 3 years now.
lots of green oak and ash and elm.
I recently installed a nice airbag helper setup in the back.
I am shopping for a 14 bolt this spring.
Anyway, the truck does the work and likes it.
But it's not built for full loads of green hardwood.
It cost me about $90 to "maintain" it.
Is it warm in here?
-yep
62K mi. on it.
I had roughly .010" to .020" radial movement on both sides.
This caused some audible clunking when driving in certain situations.
I've been loading it down with about 3000#+ for almost 3 years now.
lots of green oak and ash and elm.
I recently installed a nice airbag helper setup in the back.
I am shopping for a 14 bolt this spring.
Anyway, the truck does the work and likes it.
But it's not built for full loads of green hardwood.
It cost me about $90 to "maintain" it.
Is it warm in here?
-yep