goatchin
ArboristSite Operative
I have gotten the saw to idle correctly now (some may remeber my post from a couple weeks back)...ended up being i had a leak at the base because i didnt use enough gasket maker when i took out the base gasket. I also replaced the impulse line, but that looked to be in good condition, no dry cracking but did it to be safe.
Next problem is that when i come out of a cut, the saw will blubber out and die if i dont blip the throttle 5-6 times. It will restart fine. I have taken apart the carb and cleaned it when i re-did the base 'sealant', but did not rebuild it.
Other than rebuilding the carb, any other ideas?
Next problem is that when i come out of a cut, the saw will blubber out and die if i dont blip the throttle 5-6 times. It will restart fine. I have taken apart the carb and cleaned it when i re-did the base 'sealant', but did not rebuild it.
Other than rebuilding the carb, any other ideas?