parrisw
Tree Freak
Well, it has couple of mm lower compression hight than the 064 piston, but the skirt may be a tad short?
The measurments appear to be close to a 7900 piston, so it would work, question is about skirts.
Well, it has couple of mm lower compression hight than the 064 piston, but the skirt may be a tad short?
272 piston is the one you want.....
272 piston is the one you want.....
Don`t you have to space up the cylinder quite a bit with that one?
Hmm, I thought the pin-crown height was too much on that one too.
There you go.
I put a husky 395 piston in a bb 660 jug. Ya just gotta want to.
I put a husky 395 piston in a bb 660 jug. Ya just gotta want to.
Yeah, I`m going to try that one, but I would have preferred it to be a little lower.
i think the 288 piston is a better choice
The bigbore kit needs a 56mm.
lol wasn't thinking there was i
i've done alot of piston swap moters, don't always work out as planed
putting in a taller piston is kinda like long stroking the moter, it changes more then you think
Got the 272 piston, looks like I need to make up .173" to get the proper squish. Could just make a spacer, skirts are quite a bit shorter as well, so I don't know how much more intake that will give it.
Take some out of the squish band and some off the top of the piston. Use the spacer to set your intake timing.
Enter your email address to join: