I'm only on page 4. You guys got a lot to talk about to get to page 9.:yoyo:
Nope. Lot's of talk, but nothin's been said, lol.
I'm only on page 4. You guys got a lot to talk about to get to page 9.:yoyo:
Just wait 15 more years and you will find out that you DO feel young right now!!!!!
The day is coming when you'll WISH you could feel as good again, as you do now!
Mike
Hey it was my first attempt at modding.
What is that Niko?
I dinnit hear no names?
Some peoples panties are sure gettin' in a bunch eh?
It is no coincidence that there were no names, and I surely didn't mean to say that all sponsors are "no good". All of them has had their fine moments, but in some cases I suspect it is more about a "lucky strike" than with knowledge about what they are doing.
A prime exemple is the one that gets particularly good result with one specific saw model, and at the same time complains that he can't do what he wants to do with it (limitations in the basic design)......
Man , this thread has turned into one ugly stump
C'mon Troll.
Most saws that get shown off the most, are pretty much Hot Rods stock.
A good tune and a good chain is all a man needs anyhow?
Simon (simonizer) did a fantastic job on my MS460, but Mastermind will be doing my next work. Lots of good builders on here, I don't want a dang cookie cutter, I want a strong azz work saw that will take hours of hard use in the woods, one day I'll try one of Terry Landrum's as well. I'm just not in the high rpm, cookie cutters running against a watch, but strong saws that will increase production at no or little cost to reliabilty.
C'mon Troll.
Most saws that get shown off the most, are pretty much Hot Rods stock.
A good tune and a good chain is all a man needs anyhow?
oke: :deadhorse: :angrysoapbox: :sword: :welcome:
oke: :deadhorse: :angrysoapbox: :sword: :welcome:
What better way to spend a Friday night?
LOL your 3hrs behind gologit. Now catch up if you can.
As I indicated earlier, a large part of many gains likely come from the muffler mods and carb mods. Some of the porting work shown on here likely is (at least partly) counter-productive, even though the saw gained power after all was done. Of course it is impossible to prove what works and not, when several changes are made more or less at the same time.
Enter your email address to join: