KG441c
Keith
Brushape whatever became of the chain shapening stand?
Yup, you can always recognize Brush Ape no matter the name.
That's gonna leave a markShould be obvious with your lips epoxied to his ass.
Here's what I'd love to know. 10,000 rpms = the piston going up and down 166 times a second. How does that friggen thing have time to flow anything?
15,000 rpms is 250 times a second.
**** you *******See you homos in September.
So by cutting the squish and base arent u shortening the effective stroke of the piston?The shorter the stroke the slower the piston velocity. Depending on the stroke, a saw turning 15,000 rpm may actually have a slower moving piston, than say a small block 350 at a much lower rpm.
Not when you adjust port height and time areaSo by cutting the squish and base arent u shortening the effective stroke of the piston?
I got the 1st 4* but whats the last 7???? Lmao!! A few more letters needed**** you *******
So after adjusting it will be the same as starting point?Not when you adjust port height and time area
That's gonna leave a mark
So by cutting the squish and base arent u shortening the effective stroke of the piston?
Not necessarily. It will be wherever the builder puts it to maximize outputSo after adjusting it will be the same as starting point?
I'm gonna go ahead with my end of the "deal"......
No more smack talk about popops from me.
I'll try my best to check that sort of talk at the door.
Lot's of ways to skin a cat..........poor cat.
Oh Brush Ape......
I doubt you'll be welcome in September. No one likes an ass hole.
Brush ape is climbing up ice mans ass followed by harley T in a great big circle jerk off fun...what and were is september?
Enter your email address to join: