redunshee
Addicted to ArboristSite
Before I run this saw over with my truck, I thought of getting some thoughts. Put a Kafar 44.3 kit on saw. New seals and bearings and passed pressure vacuum check. Comp is 180. Made several cuts in good sized wood. Lots of power but once out of the cut it dies. Put it in vice and started right up but spraying carb clean between carb and flange it dies. Air leal ,correct. Here is what I've done. Gone thru three flanges. One with sealant between carb and flange, one just flange and a gasket and no sealant and finally used nuts and new carb bolts. This required pulling cylinder to accomplish. Will stall under all scenarios spraying card cleaner. Is it possible the saw will stall using carb cleaner under all scenarios and with any saw? If so why does it die after cutting. Seems to be an air leak causing it to lean out when hot but I cannot find the fix. I have a 346 and 357 and neither exhibit this stalling issue.