NuggyBuggy
ArboristSite Operative
Finally, here's some pictures of the bottom end.
This picture shows the space between the center part of the crankshaft (that goes to the piston) and the two "arms" that surround it. (If there's better terms for me to use, please let me know).
Also, the two arms in this aspect seem to look different from each other - the right one has a sort of cross hatching and the left one seems to have some vertical machining marks. Should they look the same or be symmetrical ?
Not sure if this is normal or acceptable for the bottom of a crankcase or not: I haven't been able to figure out how to clean this part very well yet.
And here's where the crankshaft when the piston would be at the bottom of its stroke.
So - what are we looking at here ?
This picture shows the space between the center part of the crankshaft (that goes to the piston) and the two "arms" that surround it. (If there's better terms for me to use, please let me know).
Also, the two arms in this aspect seem to look different from each other - the right one has a sort of cross hatching and the left one seems to have some vertical machining marks. Should they look the same or be symmetrical ?
Not sure if this is normal or acceptable for the bottom of a crankcase or not: I haven't been able to figure out how to clean this part very well yet.
And here's where the crankshaft when the piston would be at the bottom of its stroke.
So - what are we looking at here ?