Hello,
Today I went to an echo dealer to have my cs 590 carb adjusted since ive been reading that most of these saws come lean from the factory. The tech was very nice and actually pulled the caps and tuned it at the rev limiter at WOT under no load, but when I got back home to test out the saw in a log I noticed it performed slower cutting than before. Is this normal? What should I do to get the saw cutting at its peak performance.
Thank you,
Nick
Today I went to an echo dealer to have my cs 590 carb adjusted since ive been reading that most of these saws come lean from the factory. The tech was very nice and actually pulled the caps and tuned it at the rev limiter at WOT under no load, but when I got back home to test out the saw in a log I noticed it performed slower cutting than before. Is this normal? What should I do to get the saw cutting at its peak performance.
Thank you,
Nick