woods port saw video thread

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Before i ever milled ,it was all firewood to me,now every stick has a use.
I mill but not with a saw.
I'd like to saw more lumber but wood to test saws in is more important,unless it's a nice log then I still won't saw it,I'll sell it to the grade man. Lol
The band mill rarely gets used unfortunately
 
What were the stock numbers on the 288?
I didn't degree it until after the machine work. I took about .015" out of the squishband to clean it up. I then turned a .035" popup on the piston. That required dropping the jug about .050". Compression is now 200 PSI. After machine work, the port timing was 102/118-119/80. After porting it was 100/118/80. I raised the exhaust just a couple degrees to give it a little more blowdown. I was surprised how short it was from the factory. The transfers came up a degree or less jut from cleaning them up and working them over.
 

Latest posts

Back
Top