Huskybill
Addicted to ArboristSite
The husky saw studs are 9.5 mm while the Stihl saw studs are 10 mm , Stihl pro is 12.5 mm I believe. The carbide burrs should cut it. Take half the dimentions off each side. You can buy carbide drill bits for the oil hole if need be.
http://www.acresinternet.com/cscc.n...54f3341de6d0d70b88256e0e001fda90?OpenDocument
http://www.acresinternet.com/cscc.n...980fb87c02a98a5088256e0e001fee75?OpenDocument
http://www.acresinternet.com/cscc.n...8358984ddb7b31d488256e0e0020367d?OpenDocument
Or check the charts here.
http://www.acresinternet.com/cscc.n...e39f46cf37dbe4a088256e0d0051dd49?OpenDocument
I just purchased a hd drill press with a good milling table setting up my shop again
http://www.acresinternet.com/cscc.n...54f3341de6d0d70b88256e0e001fda90?OpenDocument
http://www.acresinternet.com/cscc.n...980fb87c02a98a5088256e0e001fee75?OpenDocument
http://www.acresinternet.com/cscc.n...8358984ddb7b31d488256e0e0020367d?OpenDocument
Or check the charts here.
http://www.acresinternet.com/cscc.n...e39f46cf37dbe4a088256e0d0051dd49?OpenDocument
I just purchased a hd drill press with a good milling table setting up my shop again