Mac Timber Bear(?) Hard Starting Need Advice

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
OBTW, KATO,

yes what you have is a Timber Bear, 55cc engine saw. I have one of those too.... still finishing a few things on it but compresson is good so it should be a runner.Mine is a 60013416

but yours being a Reconditioned one, they may have added the dash number or whatever. Looks clean !

Edit..... it may be an Eager Beaver 3.4 ---- I'm still trying to figure out all these Mac names and numbers!

Thanks for that.....a little confusing, it looked new when I bought it and only used it 2 or 3x.
 
I run 70:1 on mine with 0 oiler leaks and a new oiler and it still smokes more than most of my other saws. Drinks like an FSU frat boy too. Starts on 3 pulls every time

Sent from my LM-G820 using Tapatalk
 
Yeah I was going to say, I sure didn't cut very much with the PM-610 and it sure sucked down the fuel!
 
I filled mine up and got to noodle 3 oak logs in half and it was pretty much out. Small tank and a big appetite. Realistically it needs a quart fuel tank

Sent from my LM-G820 using Tapatalk
 
On my Mini-Macs, I simply drain the bar oil out when I'm not using them to avoid the puddle of oil from the oil line leaking. If you are getting oil into your crankcase you could try doing this when the saw sits.
 
On my Mini-Macs, I simply drain the bar oil out when I'm not using them to avoid the puddle of oil from the oil line leaking. If you are getting oil into your crankcase you could try doing this when the saw sits.
Good idea, I have Mini too...makes a mess.
 
On my Mini-Macs, I simply drain the bar oil out when I'm not using them to avoid the puddle of oil from the oil line leaking. If you are getting oil into your crankcase you could try doing this when the saw sits.
I found that out with it sitting on my bench with a full tank of oil lol
 
I found that out with it sitting on my bench with a full tank of oil lol

I usually try and empty the fuel before storage...when I remember, but not the oil. I put rags under the saws, not great to have oil soaked rags laying around. I wonder if the newer saws do that too?
My Mini was another hard starter....
 
Are you cracking the oil cap to release the pressure after cutting before storing?

I am now...LOL Why were they designed to leak oil, to release pressure? Why are your Mini Macs listed as dangerous, I have one too?
 
I am now...LOL Why were they designed to leak oil, to release pressure? Why are your Mini Macs listed as dangerous, I have one too?
haha... I was kidding about them leaking oil like they were designed to, i meant "as if they were designed to", because they all leak!

My signature, lol.. a running theme on this site is that top-handle saws like Mini-Macs are very dangerous to use, especially one-handed, because of the location of your right hand which can make them more likely to kick-back. So being a smart-ass I've indicated in my signature line that they are dangerous, especially the one with no chainbrake.
 

Latest posts

Back
Top