stihlboy
Guess who's back
hey guys what are the comon problems with these caps? the center of mine is breaking away from the outer edge anybody have one that i can have? im spilling gas and i need a cap asap i am willing to trade
Flippy caps on a 660what the H*** are these flippy cap things? they look weak
Flippy caps on a 660
what the H*** are these flippy cap things? they look weak
what the H*** are these flippy cap things? they look weak
They are weak. But I've been running them since before you ever touched a saw and I only have a few pairs of oil-soaked pants and chaps and some replaced o-rings to show for them. You can't get them for your 066 and I can only get them for a lot of my saws. They're progress, I guess. They're really not that fragile, but sometimes you'll dump a load on your leg because you weren't paying attention.
how did you break a normal cap??
not sure how it happened but i got the saw off ebay and when i filled it up it only leaked a little but i thought i had just spilled the gas. well that was a while ago and today i was with Kallaste at his house and i filled it up and then i noticed a leak i wiped it off and set it down and watched and it leaks from the seam of the hex threaded center and the outer ring.. my guess is it got over-tightenedhow did you break a normal cap??
I found the remnants of one in the oil tank of a saw I bought. The center had pulled out.
Enter your email address to join: