dankelly125
ArboristSite Lurker
Just picked up an 066mag. its in great shape, starts up just fine. I am unable to get the spray of oil coming off of the chain like I am supposed to. When i adjust the oiler, starting at the lowest setting, the slot in the screw is horizontal. The screw only allows me to turn it clockwise until the slot is pointing to the "E" on the gauge, which is essentially 90* from the lowest setting, and I cant turn it any further. The gauge looks like it should go further, but the screw wont turn the full 180*.
I hope this makes sense, and I hope there's a solution to the problem. I have checked the hole in the bar, its clear. I have checked the oiler hole on the saw, its clear. Without the bar, I get oil dribbling out of the hole, but it just doesnt seem like its getting to the bar/chain.
Should I be able to adjust it higher than it is? Thanks for your help!
I hope this makes sense, and I hope there's a solution to the problem. I have checked the hole in the bar, its clear. I have checked the oiler hole on the saw, its clear. Without the bar, I get oil dribbling out of the hole, but it just doesnt seem like its getting to the bar/chain.
Should I be able to adjust it higher than it is? Thanks for your help!