So I scored a 6421 at home depot for $140. It was "not running" because the salesman couldn't get it started with the switch in the off position [emoji849] popped off with one pull when I got home. [emoji2]. Already gutted the muffler.
Now the question. I have about 10 loops of 81 link .325/.063 chisel chain I want to use. Is there a combination to setup the dolkita to use the chain?
I can get a 20" .063 hard nose bar with the D009 mount. Can't find a sprocket tip in .325.
But for a sprocket I can only get the .325 with 9-pin for a standard SD7 drum. Seems like 9 pins is going to be too much. Any ideas? Can I get a drum with the small spine and run .325-7/8?
Thanks fellas.
Sent from my iPhone using Tapatalk
Now the question. I have about 10 loops of 81 link .325/.063 chisel chain I want to use. Is there a combination to setup the dolkita to use the chain?
I can get a 20" .063 hard nose bar with the D009 mount. Can't find a sprocket tip in .325.
But for a sprocket I can only get the .325 with 9-pin for a standard SD7 drum. Seems like 9 pins is going to be too much. Any ideas? Can I get a drum with the small spine and run .325-7/8?
Thanks fellas.
Sent from my iPhone using Tapatalk