I went for it. Picked up a NEW 026 pro today. 18 inch bar as I was satisfied with it on another saw.
This one came with 3/8 chain, and it cuts fairly well. My question for the masters is:
Should I swap it over to the .325?? Would I gain anything? It seems that the 3/8 is "almost" too much for it, granted I have only run it for a few minutes so the motor isn't even close to broke in.
The Jonsered that I am upgrading from is running .325 on a 18' bar, and I was satisfied with it's performance.
Thanks,
-Pat
This one came with 3/8 chain, and it cuts fairly well. My question for the masters is:
Should I swap it over to the .325?? Would I gain anything? It seems that the 3/8 is "almost" too much for it, granted I have only run it for a few minutes so the motor isn't even close to broke in.
The Jonsered that I am upgrading from is running .325 on a 18' bar, and I was satisfied with it's performance.
Thanks,
-Pat