346XP OE

[MJM268]

Will be switched to 325 so it matches my Jred saw. Saw started on the 2nd pull and sounds great. Will be taking it on a maple tree scrounge tonight.

Sent from my SM-G950U using Tapatalk

 

[redoakneck]

You need that Goofy clutch tool to change the rim sprocket . I lost mine, uggg

 

[KenJax Tree]

Not sure about the OE but the NE clutch has spots for a flathead screw driver. One good wack with a hammer spins it loose.

 

[KenJax Tree]

 

[Cantdog]

And Ken....THis is why I enjoy this site so much.......folks shearing knowledge and shortcuts etc!!


EDIT........sharing not shearing....LOL!!!

 

[MJM268]

Runs like a top and is angry at wood! Went with 18in 325. One load of maple done, many more to come

Sent from my SM-G950U using Tapatalk

 

[sunfish]

I have a couple of ne 346’s and a couple of saws with ne top ends. But I’ll take my oe any day , even if it’s 5cc smaller. Must be in the porting or something. I wish husqvarna still made the oe p/c, snooze you looze

Last I checked OE top ends were still available. @spike60

 

[sunfish]

Surprised more people don't know about this?

 

[Cantdog]

Surprised more people don't know about this?

I didn't.......but then I have the correct tool so never had to look for an alternative......nice it's there though....good thing to remember.

 

[sunfish]

I didn't.......but then I have the correct tool so never had to look for an alternative......nice it's there though....good thing to remember.

Actually the "correct" tool is the alternative way. lol

 

[MJM268]

Okay stupid question, no gasket on the bar oil seal area? Is that normal for this saw?

Sent from my SM-G950U using Tapatalk