just started using my 361 a couple of days ago, gotta say it is a smoooootttthhhh cuttin saw, and will likely replace my favorite ported 360 pro..
however, when bucking, sometimes in between cuts it'll idle down and die..
plug looks good, air filter clean, i don't git it ??
switch the trigget to fast start and it fires right back up..
i did notice when i open the fuel cap it has a hissing sound ??
was wondering if anyone else has experienced this with theirs ??
i've read that they can be a little finiky till they have some time on em, this saw's probably got about 8 tanks through it so far..
i know, i know, the 361 cures cancer and all, and ya should'nt say anything bad about em and all, but this ones got me konfuzed !!!
ok, you husky guys.......have at it....... no, i changed my mind, be quiet !!!
however, when bucking, sometimes in between cuts it'll idle down and die..
plug looks good, air filter clean, i don't git it ??
switch the trigget to fast start and it fires right back up..
i did notice when i open the fuel cap it has a hissing sound ??
was wondering if anyone else has experienced this with theirs ??
i've read that they can be a little finiky till they have some time on em, this saw's probably got about 8 tanks through it so far..
i know, i know, the 361 cures cancer and all, and ya should'nt say anything bad about em and all, but this ones got me konfuzed !!!
ok, you husky guys.......have at it....... no, i changed my mind, be quiet !!!