FarmerGrant
ArboristSite Lurker
So I bought this 365 SP 9 years ago and used it on my mill a bit. Saw was feeling pretty weak, so I decided to buy a 372 top end to put on it. 3 years later I'm finally installing it. I bolted the cylinder down, and tried turning over the engine to measure squish, (base gasket delete) and it'll only turn over half way either direction. The flywheel is contacting the cylinder. I'd rather not remove cylinder again. Should I just pop off the flywheel and grind clearance on the cylinder?
Am I missing something? This is my first time replacing a chainsaw top end.
Thank you
Attached are the parts I used
Am I missing something? This is my first time replacing a chainsaw top end.
Thank you
Attached are the parts I used