372 has a miss

[frenchy85]

A few months ago I bought a used Husky 372xp. It starts fine and runs good. But when cutting it sounds like it has a miss or something. I don't really know how to explain it it just sounds wierd. Does anybody know what this might could be.

 

[barney34]

372

saw could be adjusted to lean and tour hearing the electronic rev limiter

 

[frenchy85]

Ah that could be it, thank you very much.

 

[matt9923]

is it still under warranty?

 

[frenchy85]

no I bought it used

 

[matt9923]

no I bought it used

Could you be talking about 4-stroking?

 

[logging22]

Could you be talking about 4-stroking?

:agree2:

 

[Jtheo]

I had a Dolmar 133 that did that a couple of years ago, and after a lot of checking, I found it was jumping fire from the plug wire to the case of the saw. A new plug wire cured the miss.

 

[frenchy85]

Could you be talking about 4-stroking?

I don't know, what is 4-stroking and what does it mean?

 

[Sparky8370]

I don't know, what is 4-stroking and what does it mean?

4 stroking means that it almost sounds like a 4 stroke when held wide open with no load. Basically the carb is governing engine speed by being too rich to go any faster. At least that's how I understand it.

 

[mikefunaro]

You're going to need to get an audio or video clip....