I've been using my ms290 to cut up about 4 to 6 cord a year but sometimes I run into beautiful logs I wish I could mill into useable lumber. I came across this 372xpw with the intentions of buying an alaskan mill for and use solely as a lumber mill. I was planning on buying a muffler, bar, chain and mill and get this thing going. Saw fires right up and seems to run strong for the few minutes I've had it run but could use some adjustments to get it dialed in. Is it worth the $ to try to save or is it not worth the aggravation? The dealer down the street had a hard time trying to find the appropriate muffler given the attached tag.
Would you replace the cylinder head and try to buy the top plastic or run it as is (after getting a muffler)?
Thanks
Would you replace the cylinder head and try to buy the top plastic or run it as is (after getting a muffler)?
Thanks