Charlie Pendleton
ArboristSite Operative
Liking this saw very much, but I still want a 372 .
Been a while but I believe around 41 thousandthsWhat was your squish at before deleting your base gasket?
Tp change the squish I had to machine around 20 thousandths off the outside top lip of the piston.Had a hard time getting my measurement on this saw. Seems to be around 18-20. I don't remember my 365 being this difficult.
I would think so. Look real close in your cylinder, there's a chance you have a different year and manufacturer of the cylinder who knows it may not have the second ring like mine. I had to make if I remember right a .005 thick gasketI measured the smallest part of the solder.
Can't go wrong for that price. Its one of my favorite saws. I cut big pine mostly so mine sports a 24 inch bar all the time but with a 16 or 18inch it sounds pissed off, fun little runner.That is still a mystery but pretty sure someone used an inappropriate tool for a piston stop. I only paid 100 bucks for saw but pre owner said it only needed carb work. Liar. I got a steal either way.
You will love itView attachment 633493 I'm goona run a 16 I stole off my down 2159 for now. I got a ported 265xtorq for everything else. Can't wait to have some a little lighter to grab.
Enter your email address to join: