I've been trying this milling out for the last month or so. Thought I was doing good until I sharpened my chains. I've got 2 ripping chains from Bailey's.
When I needed to sharpen I bought this sharpener from TSC. I thought I've done it by the book, but only got 2 10ft cuts before I decided it wasn't working.
It had a lot finer dust than it did when new.
I put the bottom twist set to 10* and angled the top over 15*.
Did I get this backwards?
Sent from my SM-A526U using Tapatalk
When I needed to sharpen I bought this sharpener from TSC. I thought I've done it by the book, but only got 2 10ft cuts before I decided it wasn't working.
It had a lot finer dust than it did when new.
I put the bottom twist set to 10* and angled the top over 15*.
Did I get this backwards?
Sent from my SM-A526U using Tapatalk